All Questions
6
questions
0
votes
1
answer
76
views
Creating an IP alias for a device on another subnet behind a VPN
I set up a site-to-site VPN with IPsec between two routers.
Router 1 (DLink DSR-250V2) controls the 11.11.11.0/24 subnet.
Router 2 controls the 192.168.1.0/24 subnet.
The tunnel itself works fine. ...
- 1
0
votes
0
answers
1k
views
IPsec IKEv2 on OpenWrt fails to establish tunnel
Following these instructions in order to configure IPSec IKEv2 VPN server on OpenWRT (15.05 Chaos Calmer)
Router: Linksys AC1900-WRT
# uname -a
Linux OpenWrt 3.18.23 #1 SMP Sun Jan 31 12:53:24 CET ...
- 2,157
0
votes
0
answers
278
views
VPN, NAT - an out of the box solution
I am looking for an out of the box VPN solution for homeuser build with cheap hardware. The szenario is as easy as everywhere:
Office:
Server (private IPv4 LAN 192.168.10.x) <->
router and ...
- 103
0
votes
1
answer
84
views
How does IPsec operate in NAT environment?
I know that if you mess with IPsec header it will drop the packet and NAT is build exactly for that. How do they deploy IPsec where NAT is also needed.
- 189
1
vote
1
answer
410
views
Why IPSec ESP needs NAT-T
I understand why it is not possible to use IPSec AH over a NAT server, since the IP header is included in the MAC too.
But I am confused about ESP with Authentication (I am talking about tunnel mode, ...
- 43
1
vote
0
answers
199
views
Netgear NAT over LAN TO LAN
I have the following question:
I need to connect through a vpn IPsec lan 2 lan tunnel with a partner but they want that I connect through a specific ip subnet which is not mine. Here's the situation:
...
- 107